Skip to main content

Site Navigation

Your Account

Choose Language

Help

Current version by: Maz ,

Text:

Mine is a Keenovo 500W or 550W heated bed and printing with that turned off might have been slightly better but the walls are still wonky. Where did you put the ferrites?
 
If the heater was causing problems then that would mean that the boxzy power supply is sending through enough noise to mess up the arduino when things turned on and off somewhere else in the building on the same breaker?
 
Still looking for ideas because one of the guys at work bought

https://www.amazon.com/Monoprice-Maker-Select-Plus-Printer/dp/B01JBEF3T8/ref=sr_1_3?s=industrial&ie=UTF8&qid=1487637404&sr=1-3

and it seems to work much better.
Still looking for ideas because one of the guys at work bought

https://www.amazon.com/Monoprice-Maker-Select-Plus-Printer/dp/B01JBEF3T8/ref=sr_1_3?s=industrial&ie=UTF8&qid=1487637404&sr=1-3

and it seems to work much better.

Status:

open

Original post by: Maz ,

Text:

Mine is a Keenovo 500W or 550W heated bed and printing with that turned off might have been slightly better but the walls are still wonky. Where did you put the ferrites?

If the heater was causing problems then that would mean that the boxzy power supply is sending through enough noise to mess up the arduino when things turned on and off somewhere else in the building on the same breaker?

Still looking for ideas because one of the guys at work bought

https://www.amazon.com/Monoprice-Maker-Select-Plus-Printer/dp/B01JBEF3T8/ref=sr_1_3?s=industrial&ie=UTF8&qid=1487637404&sr=1-3

and it seems to work much better.

Status:

open