Skip to main content

Site Navigation

Your Account

Choose Language

good cura 64 bit Version 4 settings

Hi there.

I just downloaded the latest Cura V4 from Ultimaker and am having troubles getting the settings correct for the Boxzy. Does anyone use this version of Cura and can I have the settings please. Cura V4 has a Gazillion settings and it seems that pretty much all of them are geared to ruin the print. Using the Cura that came with the Boxzy produces OK results but I cant get rid of the seem on the finished print. I was hoping the newer version of Cura would help but it only makes the print look as if it is under extruding.

thanks…

Answer this question I have this problem too

Is this a good question?

Score 0

Comments:

After some research I found that Cura V4 has a bug that causes under extrusion for custom printers such as the Boxzy. I could find now way to fix this so I downgraded to V3.6 and it does not have this problem. However, the print is still a bit messy, having bumps on the outside perimeter. (I'm printing a cylinder so it's noticeable.) Any suggestions that might remove these bumps?

by

Add a comment

1 Answer

You will want to slow down your outer perimeter speed to around 20-25mm/sec, that should help a lot. That, or move to Slic3r, which usually creates less bumps, as it doesn't cross perimeter lines together the same way. I'm sure Cura has a way to turn off the crossing it does, but I don’t know it well enough to say.

Was this answer helpful?

Score 0
Add a comment

Add your answer

Paul will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 13

All Time: 13