Skip to main content

Site Navigation

Your Account

Choose Language

This page is full of resources designed to help you troubleshoot any issues that may occur as you use BoXZY.

101 Questions View all

Are G-code move values wrong in the Quick-Start guide for alignment

The G-code move commands in Steps 13-15 did not seem appropriate for leveling the 3D bed. I found instead with first level with G1 X0 Y105 Z0 (then lower the 3D print head), then G1 X140 Y25 to put the print nozzle along the diagonal from the first screw to the second screw, and then G1 X100 Y165 to put the print nozzle along the diagonal from the first screw to the third screw. With those move positions, I was able to stay on the diagonal between the screws and thus have less cross-alignment when adjusting the screws (that is, could level in first iteration and verify in second iteration).

I also staked the screws with 2216 epoxy so hopefully the 3D bed stays level without having to recheck the level for every print job.

Answered! View the answer I have this problem too

Is this a good question?

Score 2
Add a comment

2 Answers

Chosen Solution

It appears that way to me too. The given values in the set up guide didn't take me all the way to the front corners.

Was this answer helpful?

Score 0
Add a comment

Would you be willing to put a guide? This seems like great information.

Community Made Guides

Was this answer helpful?

Score 0
Add a comment

Add your answer

Tom Woods will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 128