Skip to main content

Site Navigation

Your Account

Choose Language

This section is for questions and advanced guides for BoXZY's 3D print head.

22 Questions View all

Can I select a layer for printer to continue printing at?

filament got tangled up and stopped feeding but printer continued trying to print, i have paused the file and fixed the issue but its a 12hr print and im not trying to start all over, can i select which layer for it to continue printing from?

Answer this question I have this problem too

Is this a good question?

Score 2
Add a comment

2 Answers

Most Helpful Answer

What I did is measure how high is the current print job. Then go to edit g-code menu, you will see some code for the start and put the nozzle to home position, following with set up Z position.

Trick is Z position is in millimeter. You need to look for the code that set the printer level at your current hight. (you need to go to the first position that is higher than your current. ) Now, remove the code before this Z level up to the code to set up Z position for first time, after home position. Hit print to continue print on your current level.

It is important that you do not move X-Y position on your print bed.

Was this answer helpful?

Score 1
Add a comment

I'm sorry to say, You cannot select a layer to resume on.

Was this answer helpful?

Score 0
Add a comment

Add your answer

SAF customs will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 3

All Time: 156