Skip to main content

Site Navigation

Your Account

Choose Language

Resources, questions, and answers, about the BoXZY Interface.

19 Questions View all

Laser Interface questions and help

Help, I know a lot of this is supposed to be intuitive however I have been watching video for two days and still don't have the laser extension installed in Inkscape . I would really aplpreciate some human interfacing or walkthrough. Do you all have a phone number?

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

2 Answers

Hi Craig,

You could definitely hit up for the direct phone number, but you stated your question was regarding Inkscape, correct? I can tell you, no one in the team can help you with that external software, the Inscape guides were exclusively created by users familiar with the software. However, I may be able to help. I'm not super familiar with the software, but I did help write the Inkscape guide below, using the guidance of online tutorials and other users.

Have you found this guide?

Laser etching control solutions for Mac OS X and BoXZY

Are you aware if you are running the windows Interface you do not need Inkscape?

Was this answer helpful?

Score 0
Add a comment

Wait, what? Windows interface? What do I draw with?

Was this answer helpful?

Score 0


You can draw with any program you'd like, including Inkscape and adobe, or just take a picture of something. You do not need any plug in to load those images into the windows interface. Simply save them as a jpg or png and open them inside the BoXZY laser tab of the windows interface. Or choose an image off of the internet.

The plugin is only necessary if you do not have the windows interface and are trying to run the laser without it, in MAC or Linux.

2.2 Laser Etching with BoXZY

1.2 Setting Up Your BoXZY


Add a comment

Add your answer

Craig Sorensen will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 128