Skip to main content

Site Navigation

Your Account

Choose Language

No BED PID in Firmware EEPROM Configuration

I have used the manual and run the Arudino_Heated_Bed_Settings  program, but I don’t get the bed PID in the EEPROM settings. Any suggestions?

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Does the bed function? Or it both doesn't show up or function?

Was this answer helpful?

Score 0

Comments:

The bed does not function it does show up on the manual tab but it never heats up when I turn it on.

by

It may be a simple firmware upload error. What version of Arduino are you using? It should have 3 digits in the top of the window, what do those say?

I would try to re-upload the firmware to eliminate a possible upload error.

Installing a Heated Bed

by

Arduino is 1.6.6

Boxzy 2.0.1

I did follow those instructions and get the done uploading, but it doesn't seem to update the firmware in Boxzy.

by

When you finish, does the lower window of Arduino state "done uploading"?

by

Yes I do get that.

by

Show 1 more comment

Add a comment

Add your answer

Rob Barnes will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 32