Skip to main content

Site Navigation

Your Account

Choose Language

Introduction

Many BoXZYs left the factory with the signal and ground wire for the thermistor reversed. It has only caused an issue for small number of BoXZY users, however, it should be corrected if you have the opportunity or before you do any modifications.

  1. The first pictures with the red X shows the incorrect layout. White wire on bottom, red on top. Independent red wire connected to bottom pin. The second picture show the correct layout. White wire on top, red on bottom. Independent red wire connected to upper pin.
    • The first pictures with the red X shows the incorrect layout. White wire on bottom, red on top. Independent red wire connected to bottom pin.

    • The second picture show the correct layout. White wire on top, red on bottom. Independent red wire connected to upper pin.

  2. To fix, remove the connector and swap the pins by using a paperclip or needle to push down the silver clip in the connector which will allow you to separate the pin from the connector. When removed, the wires should appear as in the second picture.
    • To fix, remove the connector and swap the pins by using a paperclip or needle to push down the silver clip in the connector which will allow you to separate the pin from the connector.

    • When removed, the wires should appear as in the second picture.

    • Once swapped, place the red independent wire into the top pin in the same way it was connected in the bottom pin when you removed it.

Finish Line

One other person completed this guide.

Just Helping

Member since: 03/08/2016

6,324 Reputation

5 Guides authored

2 Comments

Why doesn't this show up under the service bulletin tab? Only as a link from the heated bed install...NM now that I commented on it I see it.

Jared Fox - Reply

I'm surprised to see how the red independent wire is inserted into the connector. Okay, these connectors might not have provision to allow two wires to one pin, but the cleaner way would be to put a solder joint before the pin and protect it with shrink tube.

Marco Mailand - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 558