Skip to main content

Site Navigation

Your Account

Choose Language

Introduction

This guide instructs you how to replace your current bolt with a new, shorter bolt. It is only necessary for V1 and Kickstarter BoXZYs. You only need to change the clamp if you have this era of machine and purchased the Canister Alignment Clamp. The new bolt will provide you with 10mm of area on Z axis.

Tools

Parts

  1. Unscrew the current bolt (M3 x 40) located under the Z-limit activator using an alan key/hex key/wrench. It's easier to use ones that have a ball on the head. The bolt is in pretty tight, so unscrewing it might take some effort. Unscrew the current bolt (M3 x 40) located under the Z-limit activator using an alan key/hex key/wrench. It's easier to use ones that have a ball on the head. The bolt is in pretty tight, so unscrewing it might take some effort.
    • Unscrew the current bolt (M3 x 40) located under the Z-limit activator using an alan key/hex key/wrench. It's easier to use ones that have a ball on the head. The bolt is in pretty tight, so unscrewing it might take some effort.

  2. Once you have completely removed the original bolt, you're ready to put in the new, shorter bolt (M3 x 30). Before you do so, make sure that the nut is tightened as far as it will go. Then, tighten the bolt all the way down to the nut.
    • Once you have completely removed the original bolt, you're ready to put in the new, shorter bolt (M3 x 30). Before you do so, make sure that the nut is tightened as far as it will go. Then, tighten the bolt all the way down to the nut.

Conclusion

You have now replaced your limit switch!

Marge

Member since: 06/28/2017

101 Reputation

1 Guide authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 69