Skip to main content

Site Navigation

Your Account

Choose Language

  1. unplug the power supply to prevent nasty shocks! remove screws with a hex key (don't lose these!) remove screws with a hex key (don't lose these!)
    • unplug the power supply to prevent nasty shocks!

    • remove screws with a hex key (don't lose these!)

  2. remove the top of the body with care not to pull any wires stack them (see picture)
    • remove the top of the body with care not to pull any wires

    • stack them (see picture)

  3. Identify the two wires that will be cut Use a wire cutter to cut close to the key switch
    • Identify the two wires that will be cut

    • Use a wire cutter to cut close to the key switch

  4. Take your wire strippers to strip away about 3/4 of an inch on the two wires you just cut. Take your wire strippers to strip away about 3/4 of an inch on the two wires you just cut.
    • Take your wire strippers to strip away about 3/4 of an inch on the two wires you just cut.

  5. Twirl the exposed wires so they won't fray Add heat shrink to one of the wires
    • Twirl the exposed wires so they won't fray

    • Add heat shrink to one of the wires

  6. Twist the two wires together and pull the heat shrink over so that the exposed wire is no longer visible. Twist the two wires together and pull the heat shrink over so that the exposed wire is no longer visible. Twist the two wires together and pull the heat shrink over so that the exposed wire is no longer visible.
    • Twist the two wires together and pull the heat shrink over so that the exposed wire is no longer visible.

  7. Use a heat gun to seal the plastic around the exposed part of the wires Use a heat gun to seal the plastic around the exposed part of the wires Use a heat gun to seal the plastic around the exposed part of the wires
    • Use a heat gun to seal the plastic around the exposed part of the wires

  8. You're almost there! Replace the top taking care to tuck any wires into the body
    • You're almost there!

    • Replace the top taking care to tuck any wires into the body

  9. Plug in the machine before screwing it shut Make sure that the e-stop turns the power on and off  (big red button)
    • Plug in the machine before screwing it shut

    • Make sure that the e-stop turns the power on and off (big red button)

    • It is fully operational if the green light and fan come on

  10. Unplug your power supply and replace the screws
    • Unplug your power supply and replace the screws

    • Fin

Finish Line

Nicki

Member since: 09/29/2017

921 Reputation

12 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 49