Site Navigation

Your Account

Choose Language

  1. First disconnect and close the BoXZY interface. Then go to the link below and download the Firmware files: Firmware Download Unzip the firmware folder you have now dowloaded. Once unzipped, open the Firmware folder and click on the .INO file with the same name as the folder Verify you've pulled multiple files into the interface, you should see many tabs.
    • First disconnect and close the BoXZY interface. Then go to the link below and download the Firmware files: Firmware Download

    • Unzip the firmware folder you have now dowloaded. Once unzipped, open the Firmware folder and click on the .INO file with the same name as the folder

    • Verify you've pulled multiple files into the interface, you should see many tabs.

  2. Please verify you are using Arduino version 1.0.6. If you are not, you will receive compiling errors. You can dowload this version HERE Under "Tools" under "Board" select the Mega 2560 Option. Click on it even if it's already selected. Still in "Tools" go to "Processor" and select the Mega 2560 Option. Click on it even if it's already selected.
    • Please verify you are using Arduino version 1.0.6. If you are not, you will receive compiling errors. You can dowload this version HERE

    • Under "Tools" under "Board" select the Mega 2560 Option. Click on it even if it's already selected.

    • Still in "Tools" go to "Processor" and select the Mega 2560 Option. Click on it even if it's already selected.

    • Once again, in "Tools" go to "Programmer" and select the Programmer "AVRISP MkII".

  3. Verify no other USB ports are being used at this time. Make sure BoXZY's USB is plugged in but BoXZY is powered off. MAIN POWER MUST BE OFF OR DISCONNECTED, but BoXZY must be plugged into the USB. Go to "Tools" and under "Port" select the COM port your BoXZY uses, you must click on it even if it's already highlighted (It will show up with a different number than mine).
    • Verify no other USB ports are being used at this time. Make sure BoXZY's USB is plugged in but BoXZY is powered off.

    • MAIN POWER MUST BE OFF OR DISCONNECTED, but BoXZY must be plugged into the USB.

    • Go to "Tools" and under "Port" select the COM port your BoXZY uses, you must click on it even if it's already highlighted (It will show up with a different number than mine).

    • Click the green arrow in the upper left hand corner of the screen.

    • Once complete, if you have done it correctly, you will see some text at the bottom that says "done uploading". You can close the software at this point. You are done. If you get an error, repeat the steps and try again.

Finish Line

5 other people completed this guide.

Just Helping

Member since: 03/08/2016

5,667 Reputation

5 Guides authored

One Comment

If you have any questions please post them here:

http://boxzy.dozuki.com/Answers

This is so the team or other users can provide responses. Comments are not commonly reviewed by the team.

Just Helping - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 9

Past 30 Days: 19

All Time: 1,265