Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #4

Edit by Just Helping

Edit approved by Just Helping

Before
After
Unchanged

Step Lines

[title] Leveling the Platform: part 2
[* green] While the 3D Printing Head is still locked into the mount ''pull ''the Business Card out from underneath the Nozzle. The Nozzle should create a ''slight'' mark on the Business Card. Label this mark '''"Back"'''
[* orange] Send your 3D Printing Head to the ''Front Left'' corner of your BoXZY. The Gode is: ''' G1 X165 Y1'''
[* yellow] Slide your Business Cardyour business card under the Nozzle again. Withagain, using a 3mm allen key wrench you will now adjustto raise or lower the the Boltbolt in that same corner to Raise or Lower the Leveling Platform so that the Business Card is just touching the Nozzle, this iscorner, as seen in the first image
[* green] Slide
image. Adjust this bolt until the mark on the business card out from undermatches the Nozzle adjusting the screw until you get a mark matchingfirst one in depth to the first onedepth. Label it '''"Left"'''
[* yellow] Slide your Business Cardyour business card under the Nozzle again. Withagain, using a 3mm allen key wrench you will now adjustto raise or lower the the Boltbolt in that same corner to Raise or Lower the Leveling Platform so that the Business Card is just touching the Nozzle, this iscorner, as seen in the first image
[* green] Slide
image. Adjust this bolt until the mark on the business card out from undermatches the Nozzle adjusting the screw until you get a mark matchingfirst one in depth to the first onedepth. Label it '''"Left"'''
[* black] Repeat this step for the ''Front Right ''corner of your BoXZY: The Gcode is: '''G1 X165 Y165'''
[* icon_note] You will now have a Business Card withThere should now be 3 marks made byon the Nozzle at each point of leveling, ''the back'', the'' front left ''and the ''front right'', as seenbusiness card that match in the second imagedepth for ''front'', ''left,'' and ''right''
[* red] Return to the very first leveling step and repeat this process. It is important you complete this entire process a minimum of 2 times. Once this is done you have completed the leveling process
[* icon_note] You will now have a Business Card withThere should now be 3 marks made byon the Nozzle at each point of leveling, ''the back'', the'' front left ''and the ''front right'', as seenbusiness card that match in the second imagedepth for ''front'', ''left,'' and ''right''
[* red] Return to the very first leveling step and repeat this process. It is important you complete this entire process a minimum of 2 times. Once this is done you have completed the leveling process
[* icon_reminder] You will need to remove the Leveling Platform and apply a printing surface (prints will not ahere directly to metal). We recommend masking tape or Kapton Tape. An example can be seen in the 3rd image. BuildTak is one purpose made option