Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #7

Edit by BoXZY

Edit approved by BoXZY

Before
After
Unchanged

Step Lines

[title] Connecting your cables and checking your Filament Drive
[* violet] Connect your rapid swap cable to your 3D Printing Head, as seen in the first image
[* black] Next you will become familiar with your Filament Drive, this is an integral component of the 3D Printing process, the Filament Drive can be seen in the second image''second image''
[* blue] Insert a piece of paper between the Filament Bearing and the Filament Drive Gear.Gear
[* violet] Push up on the Filament Drive Lever to widen the gap between the Filament Gear and Filament Bearing

[* orange] Adjust the Filament Drive Lever tension bolt, shown in the third image,''third image,'' so that the piece of paper between the Filament Bearing and Filament Drive Gear is tight but may be pulled out without tearing
[* black] Next you will become familiar with your Filament Drive, this is an integral component of the 3D Printing process, the Filament Drive can be seen in the second image''second image''
[* blue] Insert a piece of paper between the Filament Bearing and the Filament Drive Gear.Gear
[* violet] Push up on the Filament Drive Lever to widen the gap between the Filament Gear and Filament Bearing

[* orange] Adjust the Filament Drive Lever tension bolt, shown in the third image,''third image,'' so that the piece of paper between the Filament Bearing and Filament Drive Gear is tight but may be pulled out without tearing
[* icon_note] Become familiar with the Filament Drive, you will be tweaking the tension of the Lever from time to time

Image 2

Old Version

New Version