Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #8

Edit by Just Helping

Edit approved by Just Helping

Before
After
Unchanged

Step Lines

[title] Testing the Filament Drive
[* black] Cut off about one Inch of the very end of your Filamentfilament if it is damaged or widened and straighten the nextfirst 3 Inches of Filament ofInches. This will keep the Filament Rollfilament from catching internally.
[* black] Cut off about one Inch of the very end of your Filamentfilament if it is damaged or widened and straighten the nextfirst 3 Inches of Filament ofInches. This will keep the Filament Rollfilament from catching internally.
[* blue] Squeeze the Filament Lever
[* green] Insert your Filament through the opening in the Filament lever and between the Filament Drive Gear and Bearing so that it sticks up out of the Filament Drive Nozzle a little bit, as seen in the first image
[* yellow] Squeeze firmly on your Filament with only your two fingers tips
[* red] Use the Manual Extrude button(s) in your BoXZY Interfacethe Manual Control Tab to pullmove the Filament upwards. Youupwards (3rd Image). Try to keep the filament from moving with just your finger tips while your hand is stationary. An average person should not be able to keepstop the filament from moving, iffilament. If you cancan, you will need likey need to adjustre-adjust your Filament Drive Lever tension
[* yellow] Squeeze firmly on your Filament with only your two fingers tips
[* red] Use the Manual Extrude button(s) in your BoXZY Interfacethe Manual Control Tab to pullmove the Filament upwards. Youupwards (3rd Image). Try to keep the filament from moving with just your finger tips while your hand is stationary. An average person should not be able to keepstop the filament from moving, iffilament. If you cancan, you will need likey need to adjustre-adjust your Filament Drive Lever tension

Image 1

Old Version

New Version