Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #8

Edit by BoXZY

Edit approved by BoXZY

Before
After
Unchanged

Step Lines

[title] Testing the Filament Drive
[* black] Cut off about one Inch of the end of your Filament end and straighten the next 3 Inches of Filament on yourof the Filament Roll
[* black] Cut off about one Inch of the end of your Filament end and straighten the next 3 Inches of Filament on yourof the Filament Roll
[* blue] Squeeze the Filament Lever
[* green] Insert your Filament through the opening in the Filament lever and between the Filament Drive Gear and Bearing so that it sticks up out of the Filament Drive Nozzle a little bit, as seen in the first image
[* yellow] Squeeze firmly on your Filament with only two fingers
[* red] Use the Manual Extrude button(s) in your BoXZY Interface Manual Control Tab to pull the Filament upwards. You should not be able to keep the filament from moving, if you can you will need to adjust your Filament Drive Lever tension