Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #8

Edit by Just Helping

Edit approved by Just Helping

Before
After
Unchanged

Step Lines

[title] Testing the Filament Drive
[* black] Cut off the very end of your filament if it is damaged or widened and straighten the first 3 Inches. This will keep the filament from catching internally.
[* blue] Squeeze the Filament Lever
[* green] Insert your Filament through the opening in the Filament lever and between the Filament Drive Gear and Bearing so that it sticks up out of the Filament Drive Nozzleabout a little bitinch, as seen in the first image
[* green] Insert your Filament through the opening in the Filament lever and between the Filament Drive Gear and Bearing so that it sticks up out of the Filament Drive Nozzleabout a little bitinch, as seen in the first image
[* yellow] Squeeze firmly on your Filament with only your two fingers tips
[* red] Use the Manual Extrude button(s) in the Manual Control Tab to move the Filament upwards (3rd Image). Try to keep the filament from moving with just your finger tips while your hand is stationary. An average person should not be able to stop the filament. If you can, you will need likey need to re-adjust your Filament Drive Lever tension