Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #9

Edit by BoXZY

Edit approved by BoXZY

Before
After
Unchanged

Step Lines

[title] Testing your Extruder
[* black] Lower your Leveling Platform by moving the Z axis Positive 50mm100mm
[* black] Lower your Leveling Platform by moving the Z axis Positive 50mm100mm
[* black] Squeeze the Filament Drive Lever and Pull the Filament out of the Filament Drive, cut the end of the Filament and straighten 3 Inches of the Filament
[* black] Insert the Filament into the Filament Tube and Push the Filament until you can no longer push itit, make sure you leave the 3D Print Head in the Attachment Mount
[* blue] Turn your Extruder on at 200 degrees in your BoXZY Interface in the Manual control Tab
[* green] When the Nozzle reaches 200 degrees use your hands to hold the Filament Tube and Filament and push the Filament into the Extruder
[* icon_note] This will require a fair amount of force, remember you are pushing a 1.75mm piece of plastic through a 0.4mm hole
[* yellow] If you see Filament coming out of your Extruder, similar into the third image, keep pushing and push out about 10 inches of of Filament from the Nozzle,
[* black] If you do not have success with this step please consult <this> guide
[* black] Insert the Filament into the Filament Tube and Push the Filament until you can no longer push itit, make sure you leave the 3D Print Head in the Attachment Mount
[* blue] Turn your Extruder on at 200 degrees in your BoXZY Interface in the Manual control Tab
[* green] When the Nozzle reaches 200 degrees use your hands to hold the Filament Tube and Filament and push the Filament into the Extruder
[* icon_note] This will require a fair amount of force, remember you are pushing a 1.75mm piece of plastic through a 0.4mm hole
[* yellow] If you see Filament coming out of your Extruder, similar into the third image, keep pushing and push out about 10 inches of of Filament from the Nozzle,
[* black] If you do not have success with this step please consult <this> guide

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added