Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #9

Edit by BoXZY

Edit approved by BoXZY

Before
After
Unchanged

Step Lines

[title] Testing your Extruder
[* black] Lower your Leveling Platform by moving the Z axis Positive 100mm
[* black] Squeeze the Filament Drive Lever and Pull the Filament out of the Filament Drive, cut the end of the Filament and straighten 3 Inches of the Filament
[* black] Insert the Filament into the Filament Tube and Push the Filament until you can no longer push it, make sure you leave the 3D Print Head in the Attachment Mount
[* bluered] Turn your Extruder on at 200185 degrees in your BoXZY Interface in the Manual control Tab by selecting the Extruder Icon, shown by the ''red circle'' and either drag the temperature bar to 185 or type 185 into the temperature setting box, shown by the ''red arrow''
[* green] WhenYou will know when the Nozzle reaches 200185 degrees from the read out that is shown in the first image by the ''green arrow''. When it reaches 185 degrees use your hands to hold the Filament Tube and Filament and push the Filament into the Extruder3D Print Head
[* bluered] Turn your Extruder on at 200185 degrees in your BoXZY Interface in the Manual control Tab by selecting the Extruder Icon, shown by the ''red circle'' and either drag the temperature bar to 185 or type 185 into the temperature setting box, shown by the ''red arrow''
[* green] WhenYou will know when the Nozzle reaches 200185 degrees from the read out that is shown in the first image by the ''green arrow''. When it reaches 185 degrees use your hands to hold the Filament Tube and Filament and push the Filament into the Extruder3D Print Head
[* icon_note] This will require a fair amount of force, remember you are pushing a 1.75mm piece of plastic through a 0.4mm hole
[* yellow] If you see Filament coming out of your Extruder, similar into the third image, keep pushing and push out about 10 inches of of Filament from the Nozzle,
[* black] If you do not have success with this step please consult <this> guide

Image 1

Old Version

New Version