Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #9

Edit by Just Helping

Edit approved by Just Helping

Before
After
Unchanged

Step Lines

[title] Testing your Extruder
[* black] Lower your Leveling Platform by moving the Z axis to the 100mm position
[* black] One again use a straigtened length of filament and insert it directly into the white filament tube coming from the 3d printer head. Push the filament until you can no longer push it. Make sure you leave the 3D Print Head in the Attachment Mount
[* red] Using the manual control tab, turn your extruder heater on to 210 degrees. Do this by selecting the extruder icon, shown by the ''red circle'' and either drag the temperature bar to 210 or type 210 into the temperature setting box, shown by the ''red arrow''
[* green] You will know when the Nozzle reaches 185 degreesthe target temperature from the read out that is shown in the first image by the ''green arrow''arrow'' at the bottom of the screen, and also by the black diamond on the temperature bar. When it reaches 210 degrees use your hands to hold the filament tube and push the filament into the 3D Print Head
[* green] You will know when the Nozzle reaches 185 degreesthe target temperature from the read out that is shown in the first image by the ''green arrow''arrow'' at the bottom of the screen, and also by the black diamond on the temperature bar. When it reaches 210 degrees use your hands to hold the filament tube and push the filament into the 3D Print Head
[* icon_note] This will require a fair amount of force, remember you are pushing a 1.75mm piece of plastic through a 0.4mm hole
[* yellow] Once you see filament coming out of your Extruder, similar into the third image, push through a few inches of Filament.

Image 1

Old Version

New Version