Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #9

Edit by Just Helping

Edit approved by Just Helping

Before
After
Unchanged

Step Lines

[title] Testing your Extruder
[* black] Lower your Leveling Platform by moving the Z axis Positive 100mmto the 100mm position
[* black] Squeeze the Filament Drive Lever and Pull the Filament outOne again use a straigtened length of the Filament Drive, cut the end of the Filamentfilament and straighten 3 Inches ofinsert it directly into the Filament
[* black] Insert
white filament tube coming from the Filament into the Filament Tube and3d printer head. Push the Filamentfilament until you can no longer push it, makeit. Make sure you leave the 3D Print Head in the Attachment Mount
[* red] TurnUsing the manual control tab, turn your Extruderextruder heater on at 185 degrees in your BoXZY Interface in the Manual control Tabto 210 degrees. Do this by selecting the Extruder Iconextruder icon, shown by the ''red circle'' and either drag the temperature bar to 185210 or type 185210 into the temperature setting box, shown by the ''red arrow''
[* green] You will know when the Nozzle reaches 185 degrees from the read out that is shown in the first image by the ''green arrow''. When it reaches 185210 degrees use your hands to hold the Filament Tube and Filamentfilament tube and push the Filamentfilament into the 3D Print Head
[* black] Lower your Leveling Platform by moving the Z axis Positive 100mmto the 100mm position
[* black] Squeeze the Filament Drive Lever and Pull the Filament outOne again use a straigtened length of the Filament Drive, cut the end of the Filamentfilament and straighten 3 Inches ofinsert it directly into the Filament
[* black] Insert
white filament tube coming from the Filament into the Filament Tube and3d printer head. Push the Filamentfilament until you can no longer push it, makeit. Make sure you leave the 3D Print Head in the Attachment Mount
[* red] TurnUsing the manual control tab, turn your Extruderextruder heater on at 185 degrees in your BoXZY Interface in the Manual control Tabto 210 degrees. Do this by selecting the Extruder Iconextruder icon, shown by the ''red circle'' and either drag the temperature bar to 185210 or type 185210 into the temperature setting box, shown by the ''red arrow''
[* green] You will know when the Nozzle reaches 185 degrees from the read out that is shown in the first image by the ''green arrow''. When it reaches 185210 degrees use your hands to hold the Filament Tube and Filamentfilament tube and push the Filamentfilament into the 3D Print Head
[* icon_note] This will require a fair amount of force, remember you are pushing a 1.75mm piece of plastic through a 0.4mm hole
[* yellow] If you see Filament coming out of your Extruder, similar into the third image, keep pushing and push out about 10through a few inches of of Filament from the Nozzle,
[* black] If you do not have success with this step please consult <this> guide
Filament.
[* yellow] If you see Filament coming out of your Extruder, similar into the third image, keep pushing and push out about 10through a few inches of of Filament from the Nozzle,
[* black] If you do not have success with this step please consult <this> guide
Filament.