Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #10

Edit by Just Helping

Edit approved by Just Helping

Before
After
Unchanged

Step Lines

[title] Pre Print Setup
[* red] With your Extruder still hot pull the filament completely out of the filament tube. Pull it the entire way out and turn your Extruder Heater OFF
[* black] Cut the melted end of your filament and straighten the first 3 Inches again.
[* green] Insert the Filament Tube into the tube quick release fitting, this is seen in the second image. Pull of hardup to verify it locked in place. If it becomes unlocked during a print the printer will stop extruding
[* black] Inserticon_note] Whenever you go to remove this tube, push both the Filament intotube and the Filament Drive system,quick release fitting downward. Then ''tightly'' holding the top of the fitting ''all the way ''down and pull upward on the tube
[* blue] As you see in the 3rd imge, insert the filament upwards
through the Filament Drive Gear and intoon through the Filament Tubefilament tube. Push the Filamentit the entire way into the 3D Printing Head, until you cannot push it furtherfurther. This is where the straightness of the initial filament really matters
[* black] Double Check that yourany Filament Roll is able to rotate freely and unravel the Filament as the Filament Drive pulls Filament from it
[* green] Insert the Filament Tube into the tube quick release fitting, this is seen in the second image. Pull of hardup to verify it locked in place. If it becomes unlocked during a print the printer will stop extruding
[* black] Inserticon_note] Whenever you go to remove this tube, push both the Filament intotube and the Filament Drive system,quick release fitting downward. Then ''tightly'' holding the top of the fitting ''all the way ''down and pull upward on the tube
[* blue] As you see in the 3rd imge, insert the filament upwards
through the Filament Drive Gear and intoon through the Filament Tubefilament tube. Push the Filamentit the entire way into the 3D Printing Head, until you cannot push it furtherfurther. This is where the straightness of the initial filament really matters
[* black] Double Check that yourany Filament Roll is able to rotate freely and unravel the Filament as the Filament Drive pulls Filament from it

Image 3

Old Version

New Version