Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #5

Edit by Badley Bratt

Edit approved by Badley Bratt

Before
After
Unchanged

Step Lines

[title] Mount Your Material
[* icon_reminder] Lower the Milling Platform using the positive Z platformmanual controls (shown in the red box in the first image) to create the clearance you need to mount your material. Move itthe platform down far enough so that you can '''temporarily''' set in the Milling Attachment to use the bit for alignment.
[* icon_reminder] Lower the Milling Platform using the positive Z platformmanual controls (shown in the red box in the first image) to create the clearance you need to mount your material. Move itthe platform down far enough so that you can '''temporarily''' set in the Milling Attachment to use the bit for alignment.
[* icon_note] The upcoming ''Milling Test file'' does not cut all the way through the material, so you do not need to use the sacrificial board for the following steps.
[* black] Place a piece of wood that is at least''' 3.5" x 8" x 0.5" '''in dimension onto your Milling Platform. Align the 8" length so it's parallel with the movement of the Y axis.
[* black] '''Firmly secure''' the wood to the platform. We used nuts and bolts, as shown in the third image, but you can [guide|139|clamp your material|stepid=779] instead.
[* icon_reminder] Make sure your clamps or bolts are outside of BoXZY's range of travel.