Skip to main content

Site Navigation

Your Account

Choose Language

Changes to this Step

Edit by Badley Bratt

Edit approved by Badley Bratt

Before
After
Unchanged

Step Lines

[title] Setting the X axis User Home position
[* black] Draw a line along the X axis on your Milling Material where you want your Milling File to begin, as seen in the ''first image''
[* black] With the Milling Bit above, not on, the milling material '''move''' the Attachment Mount so that the center of the bits diameter is aligned with the line you just drew
[* black] You may also use the edge of your milling material in place of drawing a line for your own Milling Files, this is shown in the ''second image''
[* black] You can unlock your Milling Attachment and set the Milling Bit on the line to verify its position on the line you drew. Be sure to lock the Milling Attachment above and not on the milling material when you are done verifying
[* red] Type '''G92 X0''' into your Gcode Sender and select '''Send'''
[* red] Type '''G1 X0''' into your Gcode Sender and select '''Send''' to verify your 0 position for the X axis
[* red] Your Milling Attachment will '''NOT''' move. If it does, realign your bit and perform the G92 command again
[* icon_reminder] It is '''extremely important '''for the machine to know where the 0 position for each axis is. If you do not verify your 0 position for each axis you risk crashing your BoXZY

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added