Skip to main content

Site Navigation

Your Account

Choose Language

Changes to this Step

Edit by Badley Bratt

Edit approved by Badley Bratt

Before
After
Unchanged

Step Lines

[title] Setting the Test Milling File User Home Position
[* black] '''Remove''' your Milling Attachment, Milling Material and Clamps from the Milling Platform
[* red] Select the '''Home All''' button in your BoXZY Manual Control tab, indicated by the ''red circle ''in the ''first image''
[* black] '''Move''' to the ''User Home'' for the Milling Test File we will begin preparing for by typing '''G1 X5 Y5 Z80''' into your Gcode Sender and select ''' Send'''
[* black] '''Set''' the ''User Home'' for this file by typing '''G92 X0 Y0''' into your Gcode Sender and select '''Send'''
[* black] Insert your Milling Attachment into your Attachment Mount and lock it with about two inches (2") of space between the Milling Platform and the Milling Bit bottom. Do not let the Milling Bit touch the Milling Material
[* black] Place a piece of wood that is at least''' 3.5" x 8" x 0.5" '''in dimension onto your Milling Platform. Make the 8" length parallel with the Y axis
[* black] Line up your piece of wood so that the Milling Bit is directly above the edge of your piece of wood, as shown in the ''second image''
[* black] As seen in the ''third image'' we used nuts and bolts to secure our wood to the Milling Platform and we are not cutting through the wood so we did not use the sacrificial board. We recommend first time users clamp their material for our Milling Test File

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added