Skip to main content

Site Navigation

Your Account

Choose Language

Changes to this Step

Edit by Badley Bratt

Edit approved by Badley Bratt

Before
After
Unchanged

Step Lines

[title] Performing an Air Pass
[* icon_note] This step is '''extremely important''' . Not all Milling Files will work the way you think. You will want to test your Milling File before you actually execute the file on your material
[* black] An '''Air Pass''' is a verification method that will execute the Milling File above your Milling Material without cutting your material
[* icon_note] Performing an ''Air Pass'' before every Milling File will help you preemptively prevent the Milling Bit from cutting your clamps, cutting the file in the wrong location and moving too fast or too slow
[* icon_note] A safe Air Pass will have spacing between the Milling Bit and the Milling Material that is larger than the deepest cut the Milling File will make. Our test file is cutting less than one quarter of an inch deep (1/4"). Let's keep one inch (1") of space for our first Air Pass
[* red] Type '''G92 Z0''' into your Gcode Sender and select '''Send'''
[* icon_caution] Keep the e-stop close, and pay attention. You may have an error in the way you set up your Milling File or in the Gcode output from your CAM program. Even the best machinist perform Air Passes with their hand on the e-stop. So watch this air cut closely with your hand on the e-stop or you risk damaging your material or your BoXZY
[* blue] Select the '''Start Print''' button, indicated by the ''blue arrow'' in the ''third image''
[* blue] Watch the test file execute and wait until BoXZY completely stops moving. Once it is stationary remove your Milling Attachment and move on to the next steps of this guide

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added