Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #10

Edit by Just Helping

Edit approved by Just Helping

Before
After
Unchanged

Step Lines

[title] Run the Milling Test File
[* icon_note] Your Milling Test file G-code will still be loaded from when you ran the air pass.
[* black] Verify one last time that your machine is in the correct '''0, 0, 0 '''position and that your bit is resting on the material.
[* black] Press the '''Start Print''' button and watch the Milling Test execute onto your material.
[* black] When the machine comes to a complete stop, orstop ''(or if an error occurs,occurs)'' '''press the e-stop''' on the power station and then turn the Milling Head power switch to '''OFF'''.
[* black] When the machine comes to a complete stop, orstop ''(or if an error occurs,occurs)'' '''press the e-stop''' on the power station and then turn the Milling Head power switch to '''OFF'''.
[* black] You should now have the word “BoXZY!” cut into your piece of wood , as seen in the image!