Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #7

Edit by Just Helping

Edit approved by Just Helping

Before
After
Unchanged

Step Lines

[title] Set the Z Start Point
[* icon_reminder] Until you set the Z Start Point, '''BoXZY does not know '''where the bit is in spacerelationship to the material. It’s extremely important that BoXZY knows this position in order to mill correctly.
[* icon_reminder] Until you set the Z Start Point, '''BoXZY does not know '''where the bit is in spacerelationship to the material. It’s extremely important that BoXZY knows this position in order to mill correctly.
[* black] Enter '''G1 X0 Y0''' into the G-code input line to send the machine back to its X0, Y0 position.
[* icon_reminder] Do '''not '''usenot use home buttons or a G28 command. They will '''undo''' your User Home position and potentially lead to a crash if anything is inside the machine.
[* red] '''Unclamp'''Unclamp the Attachment Mount and allow the Milling Head to '''gently''' slide down until the bit touches your material, as shown by the red arrows in the first image.
[* violet] Move the platform''' upwards'''platform upwards, ''allowing it to push the Milling Head up with it'' until the base of the its outer body is flush '''or''' slightly below the base of the Attachment Mount, as shown by the purple arrow in the second image.
[* icon_reminder] Do '''not '''usenot use home buttons or a G28 command. They will '''undo''' your User Home position and potentially lead to a crash if anything is inside the machine.
[* red] '''Unclamp'''Unclamp the Attachment Mount and allow the Milling Head to '''gently''' slide down until the bit touches your material, as shown by the red arrows in the first image.
[* violet] Move the platform''' upwards'''platform upwards, ''allowing it to push the Milling Head up with it'' until the base of the its outer body is flush '''or''' slightly below the base of the Attachment Mount, as shown by the purple arrow in the second image.
[* orange] Type '''G92 Z0''' into your G-code input line and hit '''Send'''. This will set the current position of your Z axis as 0
[* orange] Verify your current Z position has been set to 0 by entering '''G1 Z0'''. It should '''not''' move.
[* icon_reminder] '''Clamp your Attachment Mount'''. If the attachment can rotate with ''careful ''but firm pressure, the clamp should be tightened. Check that the clamp is '''completely''' pushed in whenever you're milling.