Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #9

Edit by Badley Bratt

Edit approved by Badley Bratt


Step Lines

[title] loading g-code for start printPlug In and Turn On the Milling Head
[title] loading g-code for start printPlug In and Turn On the Milling Head
[* black] Verify that your bit is touching your material and your Z0 is in the correct position one last time by using the '''G1 Z0''' command.
[* red] Make sure the manual e-stop is pressed down before plugging in the Milling Head and verify that the Milling Head is switched to the OFF position. The Milling Head is powered off when the circle icon, shown by the red arrow in the first image, is pressed down.
[* black] Plug the Milling Head into the BoXZY Power Station, as shown in the second image. '''Always''' use the outlet on the Power Station so you can cut power to the Milling Head with the e-stop.
[* icon_caution] You and anyone else around you should put on eye protection at this time.
[* icon_caution] Never put your hands in BoXZY when it the Milling Head is powered on and the bit is spinning.
[* yellow] Flip the Milling Head power switch to the ON position, indicated by the yellow arrow in the first image. Your bit will begin to spin.
[* red] Adjust the spindle speed to the '''4''' setting using the dial at the top of the Milling Head, indicated by the red arrow in the image.
[* black] The Milling Head's spindle spins between 10,000 and 30,000 RPM, with the '''1''' setting being 10,000 RPM and '''6''' as 30,000.

Image 3

No previous image