Changes to Step #4
Edit by Badley Bratt —
Edit approved by Badley Bratt
- Deleted
- Added
- Unchanged
Step Lines
[title] Use Your Milling Head as an Aligning Tool During Setup |
[* icon_note] Throughout this guide, we'll frequently suggest setting your Milling Head into the Attachment Mount so you can use your bit as a tool to align your material to the Milling Platform. |
[* black] An easy way to find the center of your bit is to use a thin bit with a sharp point to find the line or edge you're aligning to, as shown in the image. Set your 0 with the thin, pointed bit and then swap your work bit back into the Milling Head. |
[* icon_reminder] '''Remember:''' This is a temporary step that should never replace properly installing and locking in the Milling Head prior to setting your Z height and running your file. |
Image 1
No previous image
Added