Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #2

Edit by Nicki

Edit approved by Nicki

Deleted
Added
Unchanged

Step Lines

[title] Lets identify each panel
[* black] The enclosure consists of 5 panels: front, back, side1, side2, and the top. Lets make sure we know which is which.
[* black] First picture is the back panel. This is the only panel with a specific inside v. outside orientation. You can tell the correct orientation by the cutout. The tallest part of the cutout should on the right when looking at the back. This side should face the outside when assembling.
[* black] Second picture is the front panel. It has tabs going down the sides. No holes or cutouts in the middle.
[* black] Third picture is the side panel. It can be identified by the 2 small holes in near the center. This is where the handles will attach. There are 2 of these panels. They are identical.
[* black] Third picture is the side panel. It can be identified by the 2 small holes in near the center. This is where the handles will attach. There are 2 of these panels. They are identical.