Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #5

Edit by BoXZY

Edit approved by BoXZY

Deleted
Added
Unchanged

Step Lines

[title] Load ShinyLaser Gcode for BoXZY into Repeater-Host
[* black] Open '''Repetier -Host''', select '''Load G-Code''', as indicated by the red square in the image. Locate the file you saved from the last step and select ''Open''
[* black] Select the Gcode tab in your Repeater-Host interface and examine your Gcode. Notice'''Notice''' how the file we have loaded in the image is not positioned in the build area correctly, as indicated with the blue square
[* black] You will not be able to reposition the file in Repeater-Host butso you can compensate for the negative space that the file travels into. Continuewill need to reposition your vector(s) as seen in the next step before runningimage, indicated with a blue square. Save your Gcodefile and load it into Repetier-Host
[* black] With the laser head removed, homeMove your '''Z Axis'''. Next, measure the material that you are going to laser. Add that measurement (in millimeters) to laser focus distance of '''50.7mm.''' Move your build plateZ Axis down(positive) to the combined''combined value andyou just calculated ''and type '''G92 Z0''' in the Gcode sender'''Gcode sender''' line and select sendsend to set your Z0 location. Your laser will now be in focusfocus.
[* black] Make sure your Laser is secure and connected correctly, that your material is positioned how you want it, that you have your laser safety glasses on and press '''Run''' to run your file
[* black] Select the Gcode tab in your Repeater-Host interface and examine your Gcode. Notice'''Notice''' how the file we have loaded in the image is not positioned in the build area correctly, as indicated with the blue square
[* black] You will not be able to reposition the file in Repeater-Host butso you can compensate for the negative space that the file travels into. Continuewill need to reposition your vector(s) as seen in the next step before runningimage, indicated with a blue square. Save your Gcodefile and load it into Repetier-Host
[* black] With the laser head removed, homeMove your '''Z Axis'''. Next, measure the material that you are going to laser. Add that measurement (in millimeters) to laser focus distance of '''50.7mm.''' Move your build plateZ Axis down(positive) to the combined''combined value andyou just calculated ''and type '''G92 Z0''' in the Gcode sender'''Gcode sender''' line and select sendsend to set your Z0 location. Your laser will now be in focusfocus.
[* black] Make sure your Laser is secure and connected correctly, that your material is positioned how you want it, that you have your laser safety glasses on and press '''Run''' to run your file

Image 3

No previous image

Added