Un-box your Milling Head and mount the provided 1/4" 2-flute carbide endmill (bit), circled in red in the first image. Careful its extremely sharp!
When you install your bit, install it deeply and (as shown in the second image) tighten it enough that your work material won't pull it out, but not too tight or else it could cause other problems. It takes practice out get a feel for the right amount of torque. Err on the side of too tight
The Milling Head accepts 1/4" diameter shafts. Many different sized bits and endmills are available with a 1/4" shaft diameter. You can also use a collet reducer or a custom collet, for bits with smaller shaft diameters.
Once you've installed your bit, set aside the Milling Head for later use.
Don't insert the Milling Head into BoXZY or plug it into the Power Station just yet.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.