Skip to main content

Site Navigation

Your Account

Choose Language

Help

Step Type:

Drag to rearrange

Un-box your Milling Head and mount the provided 1/4" 2-flute carbide endmill (bit), circled in red in the first image. Careful its extremely sharp!

When you install your bit, install it deeply and (as shown in the second image) tighten it enough that your work material won't pull it out, but not too tight or else it could cause other problems. It takes practice out get a feel for the right amount of torque. Err on the side of too tight

The Milling Head accepts 1/4" diameter shafts. Many different sized bits and endmills are available with a 1/4" shaft diameter. You can also use a collet reducer or a custom collet, for bits with smaller shaft diameters.

Once you've installed your bit, set aside the Milling Head for later use.

Don't insert the Milling Head into BoXZY or plug it into the Power Station just yet.