Skip to main content

Site Navigation

Your Account

Choose Language


Step Type:

Drag to rearrange

Press the physical e-stop down before plugging in the Milling Head. Verify that the Milling Head is switched to the OFF position. The Milling Head is powered off when the circle icon, shown by the red arrow in the first image, is pressed down.

Plug the Milling Head into the BoXZY Power Station, as shown in the second image. Always use the outlet on the Power Station so you can cut power to the Milling Head with the e-stop.

You and anyone else around you should be wearing eye protection.

Never put your hands in BoXZY when it the Milling Head is powered on and the bit is spinning.

Adjust the spindle speed to the 4 setting using the dial at the top of the Milling Head, indicated by the red arrow in the third image.

Flip the Milling Head power switch to the ON position, indicated by the yellow arrow in the first image. Then twist the e-stop to power up BoXZY and the Milling Head. Your bit will begin to spin.

The Milling Head's spindle has 6 speed settings going up to 30,000 RPM. Here are the actual measured RPMs for each setting: 1 = 9470, 2 = 12280, 3 = 16870, 4 = 22175, 5 = 27035, 6 = 29800.