You want to send your machine to Machine Home using the interface home buttons when you first connect BoXZY to the computer and power it on. Do not repeat this step or use a G28 command during any part of the milling setup process.
You can use G1 commands to move your axes back to 0 during milling setup and operation.
You will have to lower your platform, by moving the Z in a positive direction, to create the clearance you need to mount your material.
Do not mount any material over the edge of the Milling Platform where it begins to taper towards the back of BoXZY, as seen in the second image shown with a red line. This would prevent the platform from moving up past that point.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.