After the fan cord has been unplugged, the board should look like the first picture. Use this image for reference for when you reconnect the wires.
There will be hot glue on the limit switch prongs. Take pliers and peel off the glue.
After peeling off the glue, unplug the limit switch harnesses.
Continue to unplug all of the wires. With the exception of the four, larger wires at the bottom of the board, they all should unplug fairly easily.
To remove the four wires at the bottom of the board, take a small, flat-head screw driver and loosen the screws clamping them down.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.