Skip to main content

Site Navigation

Your Account

Choose Language

Help

Step Type:

Drag to rearrange

Place the ground wire into the hole corresponding with the white accessory power wire, as shown in the first picture. Make sure that none of the wires are frayed or sticking out before inserting them into the hole.

If done properly, you should be able to easily slide the plug into its output casing.

Before plugging in the four extruder heating wires at the bottom of the board, twist the wires together. Make sure that none of them are sticking out. Take a screwdriver and loosen the bolts in the extruder heating plugs. Stick the end of the wires into the opening and tighten the screws until you can't turn the bolt anymore.