Reinstall your back cover. Place the bottom to the machine first and plug the top fan plug back in that we removed earlier. Visually inspect your heatsinks and make sure they are installed and not hanging off or missing.
Use your fingers to push the wires to the sides as you bring the top towards the machine. This will keep them from getting caught between the fans and the heatsinks and blocking airflow.
Place the cover holes over the bolt heads and slide down. Careful about the filament drive harness, you must make sure it's in its own groove.
Screw down cover.
Turn on power to verify there are no wires hitting the fan blades making a scratching noise.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.