Skip to main content

Site Navigation

Your Account

Choose Language

Help
Editing Step 3 —

Step Type:

Drag to rearrange

You will need to scale the EEPROM settings to reflect the size of the cylinder you are working on. You can access the EEPROM settings under the "Config" tab at the top of your interface.

The setting that affects stepper control is "Extr. 1 steps per mm." It is indicated by the red square in the third picture.

You will need to set your steps per mm before milling any item. If you do not adjusts the settings before every job, you will not achieve the proper cut.