Skip to main content

Site Navigation

Your Account

Choose Language

Help

Step Type:

Drag to rearrange

First, use your 2.5mm allen key to loosen the 4 bolts on the side of the electronics cover.

Carefully push the cover up and over the bolts to access the electronic board. Be mindful of the wiring as you pull the cover away from the machine.

Now, lets make sure the wiring on your heated bed is ready to go. The red wires should come with a 3 pin connector already attached at the end. The white wires may need stripped so that about 1/4 inch of the inner wire is exposed. Make sure the ends of the wires are neat and twisted.