At the bottom of the board you will see a row of green connectors. Use a small flat head screw driver to loosen the 2 screws on the far left that have nothing attached to them already. If you look close you will see that it is labeled HOT_BED.
Insert the 2 white wires into the open green connectors and tighten the screws so that there is a secure connection. Be sure no exposed wire is visible.
Then take the 3 pin connector at the end of the red wires and connect that to the only open connector about half way up the the right side of the board (labeled A10)
You can now carefully return the fan cover to the back panel of BoXZY and retighten the 4 bolts its mounted on.
Be sure to keep the wiring neat and out of the way of the fan blades.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.