Skip to main content

Site Navigation

Your Account

Choose Language

Help
Editing Step 8 —

Step Type:

Drag to rearrange

Locate heated bed input at the bottom of the board. It's the only one without wires installed.

Install Positive wire to the far edge and negative wire to the inside. Unscrew the flathead screw and place wire into the slot, tighten down

Check that the connection is secure and does not pull out. Verify there are no loose or free wires shorting between the positive and negative terminals.


Drag components from the list on the left to your form on the right. Click fields on the right to edit them.

Drag & Drop Components

Step 8's Form