Skip to main content

Site Navigation

Your Account

Choose Language

Help
Editing Step 5 —

Step Type:

Drag to rearrange

Use binder clips to secure the heated bed to the UNDERSIDE of the aluminum bed, making sure you are not covering the magnets.

Use heatsink plaster to cover over the thermistor and put some inside the hole you drilled earlier.

Install thermistor deep into the hole being careful not to allow a short between the wires and the aluminum

Let cure

You should drill a hole through the thickness of the platform and run a wire tie through and around the wires to support the wires and keep the thermistor from being able to be pulled out during printing (not shown here)


Drag components from the list on the left to your form on the right. Click fields on the right to edit them.

Drag & Drop Components

Step 5's Form