With an Allen wrench remove the lubricant set screw on your Z axis ball screw bearing, as seen in the first image
Next push your lubricant into the hole you just removed the set screw from
Squeeze the lubricant until you see lubricant come out of the top of the bearing between the white gasket and the ball screw, as seen in the second image
Next, manually turn the ball screw so that the Build Platform moves upwards, about 2 inches
Squeeze more lubricant into the bearing, and manually move the build platform upwards again, about 2 inches
Now you will move your build platform downwards about 4 inches
Put the set screw back into the hole where you removed it from and turn it so that it is set inside of the hole about one half turn from being flush with the hole opening
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.