First press your BoXZY e-stop and remove all the cables attached to your BoXZY
Next, use a ball-ended Allen Wrench to remove the bolt at the top of your Z axis Vertical rod, as indicated by the red circle in the first image
To safely work on your BoXZY Z axis rods and bearings, work on only one side at a time
Next, you will move your BoXZY to the edge of your work surface so that the front of your BoXZY hangs two inches over the edge of your work surface, this can be seen in the third image
The process for removing your Z axis rod, bearing and mount will be the same for both sides of your Z axis supports
Do not remove the components from both sides at the same time, disassemble one side, do what you need to then reassemble it before working on the other side
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.