Now you will remove the bearings that you removed the snap rings from
Place a Flat Head screw driver into the slot on the bearing it self and push the bearing out of the attachment mount, this is seen in the first image and indicated by the red box and red arrow
Next, use your Flat Head screw driver to push the other bearing out of the attachment head from the back of the bearing, this is seen in the second image and indicated by the red box
Now you can insert your new bearings in the same locations that you just removed them
Use your knuckle to push the bearings passed the inner groove that the snap ring fits into, this is seen in the third image
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.