Skip to main content

Site Navigation

Your Account

Choose Language


Notice: This guide has unpatrolled modifications. Before continuing, you should patrol pending changes.

From: To:

Select a difficulty level for this entire task (including any prerequisite instructions). The difficulty ranking reflects the experience, physical dexterity, and risk involved.

Very easy

Does not require opening device.


Requires minimal disassembly and requires only basic tools like a Phillips or flat-head screwdriver.


Requires a fair amount of disassembly. This is a task that most people would not perform without instruction.


Requires significant disassembly and may require specialized tasks like soldering.

Very difficult

This task is considered quite challenging, may require specialized tasks like micro-soldering, and may risk damage to the device. If you can do this, people may call you MacGyver on occasion.

If your guide picks up where an existing guide leaves off, add the existing guide as a prerequisite to avoid having to write additional steps. Prerequisite guides will be displayed before this guide. Make sure that the prerequisite guides are in the correct order. You can change the prerequisite order by dragging the icons to the left of the guide's name.

  • 1 × FB1W-HW1B-V402R - Emergency Stop Switch DPST-NC Pushlock Turn Reset Screw 10 A 600 V 220 V (QTY 1 Available from NEWARK), Emergency e-stopNeed an E-stop rated at 600VAC-10A
  • 1 × 24VDC 600W power supply (ex a MEANWELL SE-600-24 from Digikey)., SE-600-24 24VDC 600W power supplyYou may substitute a 24VDC-400Watt power supply instead such as a MEANWELL ERPF-400-24
  • 1 × RECOM R-78C12-1.0 12VDC switching voltage regulator, 12VDC switching voltage regulatorThis is done to reduce heat output from the circuit board by replacing the voltageregulator on the board
  • 1 × POWER BAR (Minimum 6 outlets rated for 20A)
Add New