Bed won't Z HomeEverything was going fine, but then… I tried to Z home and the bed lowered all the way until the limit switch stopped it. Aft...
Cutting Size larger than Easel GcodeHello, I’m very new to using a CNC Milling machine. I do what I thought was a simple cutting procedure. I mill the centers ou...
Answer to: Cutting Size larger than Easel GcodeWell you were right, the bit is a 1/4”. I fixed that in the Easel settings. I also found out by flipping the Easel home to upper left hand corner causes the Gcode to load and display properly in the Boxzy interface. With that said the creation of the jig is perfect. Using the same template in Easel for the jig, I want in and created 3 1” circles that I want to use to cut the coins with so the centers fall out, leaving the the dollar coin with a 1” hole in the center. I made the necessary circles, centered them to the circles I used to make the pockets and then deleted the pocket circles so only the path to create the hole would cut. I tried using follow path setting and the it way off, I mean off the coin. I went back and set all the path circles to inside cut. That made it a bit better but still getting slightly off center and very odd patterns, not a perfect circle. I basically just want to cut a path so the center of the dollar I’m milling just drops outs leaving a 1” hole in the coin. The team at Boxzy to...
Answer to: Cutting Size larger than Easel GcodeI mistakenly added my answer as a comment and now I can’t find it. I feel like a real tool about now.